EMC QLogic Guia de Instalação descarregar pdf (Página 123)

QLogic advanced utilities

121

Miscellaneous Planning and Procedures

QLogic advanced utilities

This section contains the following information:

◆ “Updating QLogic firmware/BIOS and applying NVRAM

settings”, next

◆ “Updating the flash BIOS using SANsurfer FC HBA Manager” on

page 122

◆ “Updating the flash BIOS using SANsurfer FC HBA Manager” on

page 122

◆ “Procedure for replacing a QLogic HBA in Stratus ftServers

without rebooting” on page 125

Updating QLogic firmware/BIOS and applying NVRAM settings

EMC-approved HBA firmware/BIOS must be applied to your HBA

before connecting to, and running I/O on, EMC Storage Arrays.

There are two ways to flash updated firmware/BIOS files to your

HBA:

◆ From QLogic SANsurfer Management Software

◆ From a DOS command prompt.

To use SANsurfer Management Software to update firmware/BIOS

on your HBA when Windows is running, refer to “Updating the flash

BIOS using SANsurfer FC HBA Manager” on page 122 for

instructions.

Note: Current 64-bit systems can on be updated only with QLogic SANsurfer

Management Software.

If you are updating the firmware/BIOS of an HBA installed in a

32-bit system that is not running the SANsurfer software, use the

procedure described in the “Install/upgrade firmware and boot BIOS

from DOS” on page 25.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 149 150

Sem comentários

EMC QLogic Guia de Instalação Página 123