EMC QLogic Guia de Instalação descarregar pdf (Página 213)

Setting the FC-AL loop ID for CLARiiON CX200 direct-connect Oracle9iRAC and RHEL 2.1 Cluster Manager

configurations with QLogic QLA234x-Series adapters

213

Special Instructions

Setting the FC-AL loop ID for CLARiiON CX200 direct-connect

Oracle9iRAC and RHEL 2.1 Cluster Manager configurations with

QLogic QLA234x-Series adapters

The FC-AL Loop ID for QLA234x-series adapters must be set

manually when directly attaching RHEL 2.1 hosts in Oracle9iRAC or

RHEL 2.1 Cluster Manager configurations.

Follow the steps below to enable hard addressing and to set the loop

ID on each adapter. Perform this procedure on both nodes in the

cluster connected to the CX200.

The topology must also be changed from the default Point-to-Point

to Loop Only. Refer to “Manually setting the topology for QLogic

Fibre Channel adapters” on page 43 for instructions.

1. Boot the Linux host.

2. Press CTRL-Q when prompted to Press CTRL-Q for Fast!UTIL.

This prompt appears with the QLogic startup

banner.

1 2 ... 208 209 210 211 212 213 214 215 216

Sem comentários

EMC QLogic Guia de Instalação Página 213