EMC Qlogic QLA22xx Guia de Instalação descarregar pdf (Página 9)

Symmetrix Fibre Channel with Qlogic HBAs on Linux Hosts

Arbitrated Loop Configurations

Verifying the Disk

Media

To verify that the HBA can see the Symmetrix, use the Fibre Disk

utility to scan and verify disk media.

1. Under the Fast!UTIL Options menu, select FIBRE DISK UTILTY.

2. You should see

SYMMETRIX in a Fibre Channel device list of all

possible 128 targets, as shown below. Page down if necessary to

display all targets in the list.

• If

SYMMETRIX appears in the list, go to step 3.

• If

SYMMETRIX does not appear in the list, verify the following,

then start this procedure again at step 1:

– that the correct Symmetrix port is connected to the host.

– that the Symmetrix is on line.

– that the cables are not damaged and are plugged in.

3. Use the arrow keys to select SYMMETRIX from the list of

targets, then press

ENTER.

4. A list of LUNs appears—select any LUN from the list.

5. A Disk Utility Options menu appears. Select VERIFY DISK

MEDIA.

6. Select CONTINUE WITH VERIFY.

7. After media verification has completed:

• If the message

Media Verification Complete appears, press

ESC repeatedly to exit Fast!Util and reboot the host, then

continue with Configuring the Host with the QLogic HBA Driver

on page 10.

• If the media verification fails, verify that:

– the Hard Loop IDs are unique between the HBA and the

Symmetrix.

– the cables and connectors are not damaged.

ID VENDOR PRODUCT REV NODE NAME

<Hard loop ID> EMC SYMMETRIX <micro code revision> 01000006048___

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 75 76

Sem comentários

EMC Qlogic QLA22xx Guia de Instalação Página 9